Metal Cascade Mini Ring (CMR)
The cascade mini ring was designed for one purpose: getting more capacity out of a column that is already built. Its shallow, asymmetric shape stacks with a preferred orientation, so the bed has a high void fraction and a short gas path. The result is a lower pressure drop per theoretical stage than a pall ring, which in vacuum service translates directly into either more throughput or a better separation at the same boil-up.
Specifications
| Parameter | Value |
| Form | Shallow asymmetric ring with stepped, cascading wall |
| Material | SS304, SS316L, carbon steel; other alloys on request |
| Nominal sizes | 25 mm, 38 mm, 50 mm, 70 mm |
| Strength | Lower mechanical strength than a pall ring; bed depth has to be checked |
| Duty | Vacuum and heat-sensitive distillation; debottlenecking |
| Loading | Orientation matters: load by the specified method, not by random dumping |
| Selection inputs | Column diameter, vapour and liquid loads, stages required, vacuum level |
Available Materials
SS304 · SS316L · Carbon steel · Duplex and other alloys on request
Typical Applications
- Vacuum distillation
- Debottlenecking existing columns
- Heat-sensitive product separation
- Absorption and stripping at high liquid load
- Fatty acid and glycerine distillation
- Solvent recovery under vacuum
How It Compares
Against a metal pall ring the CMR gives higher capacity and lower pressure drop per stage, but it is weaker mechanically and less forgiving of poor liquid distribution. Against structured packing it is far cheaper, easier to install through a manway, and it does not lose performance when the column is slightly out of level. Where a column is capacity-limited and the product is heat-sensitive, CMR is often the cheapest debottleneck available.
Frequently Asked Questions
Can I replace pall rings with CMR in an existing column?
Usually yes, and it is one of the most common revamps we quote. The capacity gain normally comes with a change in bed depth, so the hydraulics have to be rechecked. Send the existing packing size, bed height and operating data and we will do that.
Why is CMR weaker than a pall ring?
The wall is thinner and the shape more open, which is exactly what keeps void fraction high. In a deep bed that matters, because the bottom layer carries everything above it, so we check the load before recommending it for a tall column.
Does it work in vacuum service?
That is where it performs best. At low pressure the gas-phase pressure drop dominates the separation, so a packing that minimises it per stage is worth more than one with marginally higher efficiency per metre.
Is loading orientation really critical?
Yes. CMR is designed to nest in a preferred orientation. Loaded by the specified method the capacity advantage is real; dumped at random from a bag it is largely lost.
Related Products
Raschig ring in metal, plastic and ceramic. The classic random packing for simple, robust columns. Factory-dir…
Cascade Mini Ring (CMR) random packing for high-efficiency distillation and absorption. Lower height per theor…
IMTP-equivalent saddle packing for high-capacity distillation and absorption. Open, non-nesting geometry. Fact…
Get a quote for Metal Cascade Mini Ring
Tell us your flow rate, medium and operating conditions — we recommend the right packing and internals, and quote factory-direct.
Request a Quote WhatsApp